Milling

Hutch Paving offers aMilling Main Page Picturesphalt milling services. Milling asphalt can greatly reduce maintenance costs in your pavement rehabilitation. "Milling off" a specified thickness of deteriorated asphalt is recommended when your asphalt is thicker than 4.00 inches or if you have cracks in excess of 1.0 inches in width.

This process will save time and money over the high cost of complete removal of excessively thick asphalt due to the many layers of asphalt resurfacing that have been applied over the years.

Milling an entire parking area is a very cost effective process which is recommended when time is of the essence. In some cases, Hutch Paving can mill & replace a 30,000 square foot parking lot or road within the same day.

Hutch Paving also provides milling of asphalt at concrete and drain castings, prior to resurfacing, to ensure appropriate depth at these areas. This eliminates future problems caused by insufficient depth of asphalt. If you do not mill these areas, flaking will occur over time because the new material is too thin leading to premature failure.